A-18.1, r. 2 - Regulation respecting sugar bush management in forests in the domain of the State

Full text
3. A permit holder must comply with the following conditions when tapping maple trees:
(1)  maple trees may be tapped once a year only, between 1 January and 30 April;
(2)  only maple trees at least 20 cm in diameter at 1.30 m above the highest ground level may be tapped;
(3)  the maximum number of tapholes in the same maple tree is determined according to the diameter of the tree, as follows:
___________________________________________________________________________________

Diameter of maple tree at 1.30 m above ground Maximum number
of tapholes

___________________________________________________________________________________

20 to 39 cm 1
___________________________________________________________________________________

40 to 59 cm 2
___________________________________________________________________________________

60 to 79 cm 3
___________________________________________________________________________________

80 cm and over 4
___________________________________________________________________________________
Where 2 or more tapholes are drilled, they must be positioned evenly around the tree;
(4)  the taphole must be drilled using a bit not more than 11 mm in diameter and must not be more than 6 cm deep, including bark thickness;
(5)  no control product may be inserted into a taphole unless the control product has been registered under the Pest Control Products Act (S.C. 2002, c. 28);
(6)  all spouts must be removed each year at the latest on 1 June, with care taken not to tear the bark from the tree;
(7)  tubing must be installed, replaced and maintained without damage to the trees ; and
(8)  all worn or unused material must be recovered and disposed of in such a manner as to ensure the premises are kept clean.
O.C. 732-2004, s. 3.