C-24.2, r. 43.1 - Ministerial Order concerning use of flexible folding aerodynamic systems for road vehicles

Full text
Revoked on 7 April 2021
This document has official status.
chapter C-24.2, r. 43.1
Ministerial Order concerning use of flexible folding aerodynamic systems for road vehicles
Highway Safety Code
(chapter C-24.2, s. 633.2).
Revoked, M.O. 2016-04, 2016 G.O. 2, 1337.
1. The provisions of section 474 of the Highway Safety Code (chapter C-24.2) are suspended with respect to a flexible folding aerodynamic system installed at the rear of a road vehicle provided that, as shown,
(1)  any part of the system located at more than 1.9 m from the ground does not exceed, when unfolded, by more than 152 cm the rear end of the vehicle;
(2)  any part of the system located at less than 1.9 m from the ground does not exceed, when unfolded, a virtual line connecting the following points:
(a)  a point located at 1.74 m from the ground and 121 cm from the rear end of the vehicle;
(b)  a point located at the rear end and the lowest part of the vehicle bumper or, if there is no bumper, a point located at the lowest part of the rear end of the vehicle;
(3)  any part of the system does not exceed, when folded, by more than 30.5 cm the rear end of the vehicle.
M.O. 2016-04, s. 1.
2. With respect to a flexible folding aerodynamic system installed at the rear of a road vehicle, the provisions of the second paragraph of section 4.1 of the Vehicle Load and Size Limits Regulation (chapter C-24.2, r. 31) are suspended and replaced by the following:
The same applies to the flexible folding aerodynamic system located at the rear of a road vehicle, provided that, as shown,
(1)  any part of the system located at more than 1.9 m from the ground does not exceed, when unfolded, by more than 152 cm the rear end of the vehicle;
(2)  any part of the system located at less than 1.9 m from the ground does not exceed, when unfolded, a virtual line connecting the following points:
(a)  a point located at 1.74 m from the ground and 121 cm from the rear end of the vehicle;
(b)  a point located at the rear end and the lowest part of the vehicle bumper or, if there is no bumper, a point located at the lowest part of the rear end of the vehicle;
(3)  any part of the system does not exceed, when folded, by more than 30.5 cm the rear end of the vehicle.
”.
M.O. 2016-04, s. 2.
3. With respect to a flexible folding aerodynamic system installed at the rear of a semi-trailer of a road train, the provisions of subparagraphs 3 and 4 of the first paragraph of section 3 of the Special Road Train Operating Permits Regulation (chapter C-24.2, r. 36) are suspended and replaced by the following:
(3)  the first semi-trailer has a maximum length of 16.20 m and a minimum length of 12 m, in the case of a B train double, or 13.50 m, in the case of an A or C train double, the whole without taking into account the presence of a flexible folding aerodynamic system located at the rear of the semi-trailer, provided that, as shown,
(a)  any part of the system located at more than 1.9 m from the ground does not exceed, when unfolded, by more than 152 cm the rear end of the vehicle;
(b)  any part of the system located at less than 1.9 m from the ground does not exceed, when unfolded, a virtual line connecting the following points:
i.  a point located at 1.74 m from the ground and 121 cm from the rear end of the vehicle;
ii.  a point located at the rear end and the lowest part of the vehicle bumper or, if there is no bumper, a point located at the lowest part of the rear end of the vehicle;
(c)  any part of the system does not exceed, when folded, by more than 30.5 cm the rear end of the vehicle;
(4)  the second semi-trailer has a maximum length of 16.20 m and a minimum length of 12 m, without taking into account the presence of a flexible folding aerodynamic system located at the rear of a road vehicle and complying with subparagraph 3;
”.
M.O. 2016-04, s. 3.
4. This Order is revoked on 7 April 2021.
M.O. 2016-04, s. 4.
REFERENCES
M.O. 2016-04, 2016 G.O. 2, 1337